Find Your Part:

Model Selected:

2012 Audi A5

Submodel / Qualifier: Direct TMPS

SKU Results:

Sens.it RS+ Sensor: 234234

TPMS Sensor Frequency: 315

OEM Valve: None

OEM Service Kit: 59112

OEM Service Kit Torque: 8 (71)

Universal Service Kit: U1-3

Universal Service Kit Torque: 6 (53)

Overview of TPMS Relearn Procedures

 

General instructions for the TPMS relearn procedures for various vehicle manufacturers. The steps for some vehicles might be slightly different so please refer to the owner’s manual for more information.

Fiat-Chrysler vehicles
including Alfa Romeo, Dodge, Jeep, Maserati & Ram
Auto-learning

Ford vehicles
including Lincoln & Mercury
Manual learning

German vehicles
Audi/Porsche/Volkswagen, BMW/Mini, Maybach/Mercedes
Auto-learning

GM vehicles
Buick, Cadillac, Chevrolet, GMC, Hummer, Pontiac & Saturn
Manual learning

Japanese vehicles
Acura/Honda, Lexus/Scion/Toyota, Infiniti/Nissan, Mitsubishi & Subaru
OBD-learning

Korean vehicles
Genesis, Hyundai & Kia
OBD-learning

Suzuki vehicles
Manual learning

Tesla vehicles
Auto-learning

Volvo vehicles
Auto-learning

More information on the different types of relearn procedures (general instructions):

Automatic learning
Park the vehicle for 20 minutes then drive it for 10-20 min.
Note: some vehicles must be in learn mode before driving starts, which can be initiated using the dashboard buttons.

Ford
Enable learn mode: start with the ignition off. Tap the brake, turn the ignition from off to run 3 times (leaving it in run), tap the brake, turn the ignition off, then turn it from off to run 3 times. The horn should beep. Leave the ignition on.
Test each sensor using a TPMS tool: front-left, front-right, rear-right then rear-left. The horn should beep when each sensor is tested.
Turn the ignition off – the horn shouldn’t beep.
Note: on some models, TPMS relearn mode is initiated using the hazard-flasher switch.

General Motors
Enable learn mode: turn the ignition on, then hold the key fob’s lock & unlock buttons until the horn beeps.
Test each sensor using a TPMS tool: front-left, front-right, rear-right then rear-left. The horn should beep when each sensor is tested, then it should beep twice at the end.
Note: some vehicles enter learn mode using the dashboard buttons or steering-wheel buttons – navigate to the tire display then hold the enter button for a few seconds until the horn beeps.

OBD-learning
Test each sensor using a TPMS tool then connect the device to the vehicle’s diagnostic port and register the new sensor IDs.

Suzuki
Enable learn mode: Turn the ignition on and open the driver-front door. Press the door-open switch for 2 seconds, then release it. Press the door-open switch again for at least 2 seconds, then release it. Finally, press the switch for 2-5 seconds then release it. The tire warning light should start blinking.
Note: the door-open switch must be pressed within 5 seconds of turning the ignition on, and the above steps must be performed with 15 seconds.
Test the front-left sensor – the warning light should blink 3 times. Test the front-right sensor – the light should blink twice. Test the rear-right sensor – the light should blink once. Test the rear-left sensor – the light should come on for 5 seconds, then turn off. Turn the ignition off.
Additional note: after enabling learning mode, each sensor must be triggered within 90 seconds.